B2500 SE Regular Cab 2WD L4-2.5L VIN C (1998)
Crankshaft Position Sensor: Service and Repair
1. Disconnect negative battery cable.
2. Drain the cooling system.
3. Remove the drive belt.
4. Remove the bolts and position the generator out of the way.
5. Remove the lower radiator hose from the water pump inlet tube.
6. Remove the heater water hose from the water pump inlet tube.
7. Remove water pump inlet tube.
8. Remove O-ring from the water pump inlet tube.
9. Disconnect the crankshaft position sensor.
10. Remove the screw and crankshaft position sensor.
NOTE: The engine front cover design precisely locates the crankshaft position sensor so that an adjustment is not required.
11. Install in reverse order of removal.
Torque: 8-12 Nm (82-122 kgf/cm 71-106 in.lbs.)
