B2500 SE Regular Cab 2WD L4-2.5L VIN C (1998)
5.
Locate the gray/white wire at location B.
^
Cut and splice in a butt connector (provided in kit) approximately 85 mm from the TPS connector using the above procedure.
6.
Locate the gray/red wire at location C.
^
Cut and splice in a butt connector (provided in kit) approximately 125 mm from the TPS connector using the above procedure.
7.
Reinstall plastic sheating.
8.
Tape over all wiring and sheathing with electrical tape or equivalent.
9.
Install TPS connector to TPS sensor.
Disclaimer
Technical Service Bulletin # 0101100R
Date: 000728
Throttle Position Sensor (TPS) - High Idle Speed
Bulletin No.: 011/00R
Issued: 06/23/00
Revised: 07/28/00
Section
01
Applicable Model/s
1998-2000 B-2500
Subject
HIGH IDLE - MANUAL TRANSMISSION
BULLETIN NOTE
^
This bulletin supersedes 01-011/00. The REPAIR PROCEDURE section has been revised.
APPLICABLE MODEL(S)VINS
All 1998-2000 B-2500 with manual transmission.
DESCRIPTION
Some vehicles may exhibit a high idle. This may be caused by a poor electrical connection at the wire harness to the Throttle Position Sensor (TPS). A
service kit is available to resolve this concern. Customers having this concern should have their vehicle repaired using the following procedure.
REPAIR PROCEDURE
1.
Verify customer concern.
