B2500 SE Regular Cab 2WD L4-2.5L VIN C (1998)
5.
Locate the gray/white wire at location B.
^
Cut and splice in a butt connector (provided in kit) approximately 85 mm from the TPS connector using the above procedure.
6.
Locate the gray/red wire at location C.
^
Cut and splice in a butt connector (provided in kit) approximately 125 mm from the TPS connector using the above procedure.
7.
Reinstall plastic sheating.
8.
Tape over all wiring and sheathing with electrical tape or equivalent.
9.
Install TPS connector to TPS sensor.
Disclaimer