B2500 SE Regular Cab 2WD L4-2.5L VIN C (1998)
WARRANTY INFORMATION
Note:
^
This information applies to verified customer complaints on vehicles covered under normal warranty. Refer to the SRT microfiche for warranty
term information.
THROTTLE POSITION SENSOR (TPS) CONNECTOR INSTALLATION INSTRUCTIONS.
1.
Unhook TPS connector.
2.
Cut TPS connector off at connector and remove plastic sheathing.
3.
Install sheathing on new TPS connector pigtail.
4.
Locate the brown/white wire at location A.
^
Cut and splice in a butt connector (provided in kit) approximately 45 mm from the TPS connector.
^
Crimp butt splice connector and shrink tubing with heat gun of an acceptable heat source.
