B3000 V6-3.0L (2007)
Brake Caliper: Removal and Replacement
Brake Caliper
BRAKE CALIPER
Removal
Warning:
^
Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the
brakes inoperative. Failure to follow these instructions may result in personal injury.
Warning:
^
Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid
contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water
and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
Caution:
^
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the brake caliper flow bolt and position the brake hose aside.
^
Discard the 2 copper washers.
^
Plug the brake hose.
Caution:
^
Do not pry in the caliper sight hole to retract the pistons as this can damage the pistons and boots.
3. Remove the 2 brake caliper pin bolts and the brake caliper.
^
If leaks or damaged boots are found, install a new disc brake caliper.
Installation
Caution:
^
Tighten the bottom caliper bolt before tightening the top caliper bolt.
Caution:
