B3000 V6-3.0L (2007)
2. Rotate the crankshaft until the No. 1 cylinder is at top dead center (TDC) of the compression stroke and the TDC mark lines up with the timing
mark.
3. Disconnect the camshaft position (CMP) sensor electrical connector.
NOTE: Prior to the removal of the camshaft position (CMP) sensor, note the position of the CMP sensor electrical connector. The installation
procedure requires that the electrical connector be located in the same position.
4. Remove the screws and the CMP sensor.
5. Remove the bolt.
NOTE: The oil pump driveshaft might come out with the camshaft synchronizer. If so, retrieve the oil pump driveshaft before proceeding.