B3000 V6-3.0L (2007)
1. Install the RCM and the 3 bolts.
Tightening torque :12 N.m (1.2 kgf.cm, 9 ft.lbf)
2. Make sure the large RCM connector position assurance laver is in the full RELEASE position before attempting to connect the connector.
CAUTION: Putting the large RCM electrical wiring connector into the RCM on an angle can cause bad electrical connection and
damage components.
NOTE: The RCM has been removed for clarity.
CAUTION: Do not push the connector to where the lever pivots and seats itself. Light pressure is needed to get the connector into
position on the RCM before using the lever to fully seat the connector.
