B3000 V6-3.0L (2007)
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the sensor
or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
-
To reduce the risk of personal injury, do not use any memory saver devices.
CAUTION:
-
When installing a new RCM, it is necessary to carry out programmable module installation (PM).
-
Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
All vehicles
1. Carry out the steps necessary to prepare for programmable module installation (PM).
2. Depower the system. See DEPOWERING AND REPOWERING.
Vehicles with high-series floor console
3. Remove the floor console. See FLOOR CONSOLE.
Vehicles with a consolette
4. Remove the consolette tray mat.
5. Remove the 4 screws and remove the consolette tray.
All vehicles
6. Disconnect the small RCM electrical connector.
7. Disconnect the large RCM electrical connector.
1. Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops.
2. Pull out and disconnect the RCM electrical connector.
8. Remove the 3 bolts and the RCM.
Installation
All vehicles
WARNING: The tightening torque of the RCM to bracket retaining bolts is critical for correct system operation.
