B3000 V6-3.0L (2007)
4. Connect the passenger air bag module electrical connector.
5. Close the glove compartment door.
6. Remove the restraint system diagnostic tools from the clockspring electrical connectors at the top of the steering column.
CAUTION:
-
Do not install the driver air bag module electrical connectors by the locking buttons. Damage to the locking buttons can occur.
-
The driver air bag module electrical connector locking buttons must be in the release position when the connector is being installed or
connector damage may occur.
-
The driver air bag module electrical connectors are unique and cannot be reversed when connected to the driver air bag module.
Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connector into the driver air
bag module.
7. With the locking buttons released, install the driver air bag module electrical connectors fully into the driver air bag module and seat the locking
buttons.
8. Install the 2 driver air bag module bolts (1 shown).
WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to
remove could result in injury and possible violation of vehicle safety standards.
9. Make sure all restraint system diagnostic tool(s) that may have been installed during the repair have been removed from the vehicle and all SRS
components are connected.
10. Turn the ignition from OFF to ON.
11. Install the RCM fuse 8 (10 A) to the SJB.
WARNING: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the
battery ground cable is connected.
