mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Seat Belt > < Arming and Disarming|Page 3640
Page 5
background image

12. Connect the battery. See BATTERY DISCONNECT.
13. Prove out the supplemental restraint system (SRS) as follows: Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to

ON and visually monitor the air bag indicator with the air bag modules installed. The air bag indicator lights continuously for approximately 6
seconds
 and then turns off. If an air bag supplemental restraint system (SRS) fault is present, the air bag indicator will either:
-

fail to light.

-

remain lit continuously.

-

flash at a 5Hz rate (RCM not configured).

The air bag indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position.
This is the time required for the RCM to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault exists, a chime
sounds in a pattern of 5 sets of 5 beeps. If this occurs, the air bag indicator and any SRS fault discovered must be diagnosed and repaired. Clear all
continuous DTCs from the RCM using the IDS or equivalent tester.

Seat Belt > < Arming and Disarming|Page 3640