B3000 V6-3.0L (2007)
Seat Belt Buckle: Removal and Replacement
60 Percent Bench
SAFETY BELT BUCKLE AND PRETENSIONER - 60 PERCENT BENCH
Safety Belt Buckle And Pretensioner - 60 Percent Bench
Removal and Installation
WARNING:
-
All safety belt assemblies (including retractors, belt tension sensor [BTS] [if equipped], buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use
during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow
these instructions could increase the risk of injury in collisions.
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in personal injury.
NOTE:
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the SRS. See DEPOWERING AND REPOWERING.
