B3000 V6-3.0L (2007)
3. Release the inboard side bottom J-clip for access to the safety belt buckle pretensioner.
NOTE: Note the routing of the wire harness through the seat for installation.
4. Detach the pin-type retainers and safety belt buckle pretensioner wire harness from the seat cushion pan.
-
For driver seat, disconnect the seat position electrical connector.
-
For the passenger seat, disconnect the safety belt buckle pretensioner electrical connector.
5. Remove the nut and safety belt buckle pretensioner and wire harness.
Tightening Torque: 40 N.m (4.1 kgf.m, 30 ft.lbf)
NOTE: Make sure the safety belts and buckles are accessible to the occupants after installation.
6. To install, reverse the removal procedure.
7. Install the seat and repower the SRS. Do not prove out the SRS at this time.
Passenger seat
WARNING: Make sure the front passenger seat repair is complete, the seat is completely assembled, all components (head restraint, seat side
shield, etc.) are correctly installed and the front passenger seat is correctly installed to the vehicle before carrying out the OCS system reset.
Failure to follow these instructions may increase the risk of personal injury or death in a crash
CAUTION: Make sure the seat is completely assembled before carrying out the OCS system reset active command.
-
The following precautions must be taken before carrying out the OCS system reset:
-
Make sure the OCS system components are connected and no faults are present
-
Make sure the voltage to the OCS module is above 8.0 volts and less then 18.0 volts
-
Make sure the OCS system is not at a temperature below 6 °C (42 °F) or above 36 °C (97 °F) when initiating the OCS system reset
process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature
within the limits, 6 °C to 36 °C (42 °F to 97 °F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat during
the process.
-
Make sure a minimum 4-second time period has passed after cycling the ignition switch ON before the carrying out the OCS system
reset process.
NOTE:
-
If the first attempt to carry out the OCS system reset is unsuccessful and DTC C1941 is reported, a second attempt must be made. If on the second
attempt to carry out the OCS system reset is unsuccessful and DTC C1941 is reported a second time, a new OCS system service kit must be
installed.
8. Carry out the OCS system reset.
-
With the front passenger seat empty, use a IDS or equivalent tester to trigger the active command.
All seats
NOTE: The ignition switch must be cycled after the OCS reset.
9. Prove out the SRS as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS fault is present,
the air bag indicator will:
-
fail to light.
