B3000 V6-3.0L (2007)
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
All safety belt tractors
1. Remove the cover and nut and D-ring from the safety belt height adjuster.
Tightening Torque: 40 N.m (4.1 kgf.m, 30 ft.lbf)
2. Remove the cover and bolt and position aside the safety belt anchor.
Tightening Torque: 40 N.m (4.1 kgf.m, 30 ft.lbf)
Passenger safety belt retractor
3. Depower the supplemental restraint system (SRS). See DEPOWERING AND REPOWERING.
NOTE: Note safety belt routing for installation.
4. Remove the B-pillar trim panel and disconnect the belt tension sensor electrical connector. See B-PILLAR TRIM PANEL - 2 DOOR, REGULAR
CAB.
-
Release the wiring harness pin-type retainers.
-
Route out the safety belt webbing.
All safety belt retractors
5. Remove the B-pillar trim panel. See B-PILLAR TRIM PANEL - 2 DOOR, REGULAR CAB.
6. Remove the bolt and safety belt retractor.
Tightening Torque: 40 N.m (4.1 kgf.m, 30 ft.lbf)
7. To install, reverse the removal procedure.
Passenger safety belt retractor
8. Repower the SRS. See DEPOWERING AND REPOWERING.
All safety belt retractors
9. Check the active restraint system for correct operation.
