mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Steering - Front End Popping/Clunking on Low Speed Turns|Page 3231 > < Steering Wheel|Service and Repair
Page 1
background image

Tie Rod End: Customer Interest
Steering - Front End Popping/Clunking on Low Speed Turns

Bulletin No.: 06-004/08

Last Issued: 03/04/2008

Subject:
POP/CLICK/CLUNK NOISE FROM FRONT END WHEN TURNING AT SLOW SPEEDS

APPLICABLE MODEL(S)/VINs
2007 B-Series vehicles

DESCRIPTION

Some vehicles may exhibit a popping, clunking, and/or clicking noise from the front end of the vehicle. The noise will happen between 3-8 mph (5-13
km/h) on a paved surface while turning the steering wheel +/- 90 degrees from the straight ahead position. This noise may be coming from the inner
tie-rod ends.

Customers having this concern should have their vehicle repaired using the following repair procedure.

REPAIR PROCEDURE

1.

Verify customer concern.

NOTE:

If the source of the noise is not from the inner tie-rod ends, refer to MS3 online instructions or Workshop Manual section 02-01 
SUSPENSION NVH DIAGNOSIS.

2.

Replace both inner tie-rod ends. Refer to MS3 online instructions or Workshop Manual section 06-12 INNER TIE ROD.

3.

Verify repair.

PART(S) INFORMATION

WARRANTY INFORMATION 

Steering - Front End Popping/Clunking on Low Speed Turns|Page 3231 > < Steering Wheel|Service and Repair