B3000 V6-3.0L (2007)
4. Evaluate the other front wheel.
^
While holding the previously evaluated wheel, run the vehicle to 40 km (25 mph). Release the wheel being held.
^
Place the stethoscope on the knuckle near the wheel bearing.
^
Make a mental note of the sound. Using the brakes, stop the wheels from turning.
5. Compare the results.
^
If one side sounds significantly louder than the other, go to Step 9.
^
If both sides sound equally loud, go to Step 9.
^
If both sides sound similar (not loud or noisy), wheel bearings are OK.
Note:
^
Make sure the wheel rotates freely.
Note:
^
Rotate the hub-locks to the unlocked position.
6. Carry out the following steps for the wheel bearing endplay setup:
^
Install the (SST 100-DO02 or equivalent) to the knuckle.
^
Place the probe on the brake disc where the splash shield has a "V" opening.
^
Make sure the probe can move in a lateral direction.
^
Tighten the neck of the probe.
7. Carry out the following steps for the wheel bearing endplay:
^
Push the wheel inward at the 6 o'clock position.