B3000 V6-3.0L (2007)
Warning:
^
The TPMS band is under tension. Always use safety goggles or a face shield and gloves when removing the TPMS band/strap. Failure
to follow these instructions may result in personal injury.
2. Remove a factory installed strap in the following sequence:
1. Locate the strap buckle and secure the strap to the wheel using duct tape or a similar item, on both sides of the buckle approximately 25 mm
(0.98 in) from the buckle.
2. Using a large screwdriver and a twisting motion, unbuckle the strap.
3. Discard the strap.
3. To remove a dealer installed strap, turn the worm gear screw until the strap is fully released from the worm gear.
^
Discard the strap.
Note:
^
To aid assembly, mark the location of the cradle prior to disassembly.
4. Using a screwdriver, or similar tool, remove the cradle by inserting the screwdriver under the cradle and prying up.
Assembly
Note:
^
Make sure the sensor is fully seated into the new cradle. The sensor will make a "click" noise when fully seated.
1. Position the sensor into the new cradle by inserting the hinge end of the sensor into the hook end of the cradle and pushing the opposite end of the
sensor down onto the cradle.
Caution:
^
Metal scrapers can damage the wheel. Use only plastic or non-metallic scrapers to remove the cradle adhesive strip residue.
Note:
^
The sensor and cradle must be installed in the drop well of the wheel, 180 degrees from the valve stem.
2. Clean the area where the sensor and cradle are to be installed.
