B3000 V6-3.0L (2007)
8. Using servo cover compressor SST, remove the overdrive band servo cover retaining ring.
(1) Install the servo cover compressor SST and compress the overdrive/front band servo cover.
(2) Remove the overdrive/front servo cover retaining ring.
^ Slowly remove tension on the J-hook nut and remove the servo cover compressor.
Caution:
^
The servo removal tool SST should be used to prevent damage to the servo and bore.
9. Use the servo removal tool SST to remove the front band servo cover, servo piston and servo piston spring.
(1) Insert the servo removal tool SST into the transmission case, locate on the servo rod, and remove the front band servo cover, servo piston and
servo piston spring.
Installation Note
1. Assemble the intermediate band servo cover, intermediate band servo piston, and the servo piston spring.
(1) Install the intermediate band servo piston into the intermediate band servo cover.
(2) Install the servo piston spring on the intermediate band servo piston.
Caution:
^
Do not damage O-ring during installation. Do not press servo cover and O-ring past relief hole in case, or O-ring damage may
occur.
2. Install the intermediate band servo piston assembly into the transmission case.
^
Lubricate intermediate band servo cover O-ring with petroleum jelly.
