B3000 V6-3.0L (2007)
Caution:
^
Do not pry on the other wires or damage the connector case surface.
7. Disconnect the turbine shaft speed (TSS) sensor electrical connector from the 16 pin transmission case electrical connector.
(1) Disconnect the TSS sensor electrical connector.
(2) Remove from the TSS sensor wire locator.
Caution:
^
Do not overstretch the retaining spring.
8. Remove the 16 pin transmission case electrical connector retaining spring.
Caution:
^
Do not damage the connector or harness.
9. Remove the 16 pin transmission case electrical connector.
(1) Compress the tabs on the 16 pin transmission case electrical connector.
10. Push the 16 pin transmission case electrical connector out of transmission case.