B3000 V6-3.0L (2007)
Caution:
^
Do not damage the inner wheel bearing oil seal.
7. Remove the two axle shafts.
Installation Note
Caution:
^
Make sure the machined surfaces on both the rear axle housing and the rear differential housing cover are clean and free of oil before installing the
new silicone sealant. The inside of the rear axle must be covered when cleaning the machined surface to prevent contamination.
1. Clean the gasket mating surface of the rear axle and the differential housing cover.
2. Lubricate the lip of the wheel bearing oil seal with grease.
Caution:
^
Do not damage the wheel bearing oil seals.
3. Install the two axle shafts.
Caution:
^
Do not damage the rubber O-rings in the axle shaft grooves.
4. Install the U-washers.
1
Position the two U-washers; on the button end of the axle shafts.
2
Pull the axle shafts outward.
