B3000 V6-3.0L (2007)
Wheel Bearing: Testing and Inspection
WHEEL BEARING INSPECTION
Note:
^
Inspect the tires for cupping. A tire with cupping wear can duplicate a bearing noise.
2WD vehicles
1. Raise the vehicle until the tire is off the floor.
Note:
^
Make sure the wheel rotates freely and the brake pads are retracted sufficiently to allow movement of the tire and wheel assembly.
2. Grasp each front tire at the top and bottom and move the wheel inward and outward while lifting the weight of the tire off the front wheel bearing.
3. If the tire and wheel (hub) is loose on the wheel spindle.
^
Adjust the front wheel bearings.
4WD vehicles
Note:
^
An assistant will be needed for this procedure.
^
This procedure also includes the hub removal and installation references.
1. Position the vehicle on a hoist.
2. Carry out the following steps:
^
Engage the transfer case to the 4H position.
^
With the vehicle in DRIVE, run the vehicle to 40 km (25 mph).
Note:
^
If the vehicle is equipped with a limited slip front axle, both the wheels will be turning. Evaluate both wheels at this time, then continue to
Step 8.
3. Evaluate the front wheel that is turning.
^
Place the stethoscope on the knuckle near the wheel bearing.
^
Make a mental note of the sound.
^
Using the brakes, stop the wheels from turning.
Note:
^
If the vehicle is equipped with a limited slip front axle, do not hold the wheel. Evaluate both simultaneously Go to Step 8.
