B3000 V6-3.0L OHV (2006)
WARNING:
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result In personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
It a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the restraint control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Driver seat shown, passenger seat similar.
1. Depower the SRS.
2. Remove the affected seat.
3. Remove the seat cushion assembly.
NOTE: Note routing of seat back latch release cable through the seat cushion pan.
4. Detach the seat back latch release cable retainer and remove the cable.
5. Release the cushion J-clips.
6. Remove the seat cushion pan from the cushion foam pad.
7. Remove all the hog rings and remove the seat cushion trim cover.
Assembly
