B3000 2WD V6-3.0L OHV (1994)
Antenna Mast: Technical Service Bulletins
Power Antenna Mast - Replacement
Bulletin No.: 005/95
Issued: 3/28/95
Revised
Category
T
Applicable Model/s
See Below
Subject
POWER ANTENNA MAST REPLACEMENT
APPLICABLE MODELS/VINS
All vehicles equipped with a power operated antenna.
DESCRIPTION
It is not necessary to replace the entire antenna assembly if an antenna mast is damaged. Follow the procedures below to replace only the mast portion of
the assembly.
NOTE:
Bent or broken antenna masts (i.e. damage not due to defects in material and workmanship) are not covered under vehicle warranty.
REPAIR PROCEDURES
1.
Remove the mounting nut with snap ring pliers or a spanner wrench.
2.
Hold the mast and have an assistant turn the radio "ON". If the antenna mast does not pop up, use slip joint pliers to pull the mast up.
NOTE:
Holding the antenna mast is necessary to prevent paint damage.
3.
Remove any debris from the ground plate, rubber bushing and mounting nut.
4.
Apply a small amount of lubricant to these pieces.