B3000 2WD V6-3.0L OHV (1994)
11.
Locate the fuel pump ground wire (BLACK) in the wiring harness on the left frame rail. Refer to Fig. 3.
12.
Locate one (1) unused 12 mm hole in the left side frame rail between the fuel pump and the fuel filter.
13.
Thoroughly clean around the selected hole to ensure a good electrical connection.
14.
Cut the fuel pump ground wire to prevent it from acting as an antenna.
^
1991 - 94 Navajo and 1994 B-Series - Cut the fuel pump ground as close to the 12 mm frame rail hole as possible.
^
1995 96 B-Series - Cut the fuel pump ground wire just before the X1007 connector. Seal the back of the X1007 connector to prevent water
from entering.
15.
Attach a eyelet connector to the fuel pump side of the ground wire and secure the wire to the frame rail with a bolt, nut and washer.
16.
Cover the ground with rust-proofing paint to prevent corrosion.
NOTE:
Since this wire is the operating ground for the fuel pump, conosion protection is especially important.
17.
Verify that the noise is reduced.
PARTS INFORMATION
WARRANTY INFORMATION
(Applies to verified customer concerns an vehicles covered under normal warranty. Refer to the SRT microfiche for applicable warranty term
information).
Disclaimer
