B3000 2WD V6-3.0L OHV (1994)
NOTE:
If the flange nut and bolt are not available, a grade 5 hex nut and bolt with fiat washers under the bolt head and nut may be substituted.
CAUTION:
The following clearances must be present after installation:
^
Minimum of 12.7 mm (1/2 in.) between the bolt and adjacent components except engine and transmission.
^
Minimum clearance between the bolt and the engine and transmission components is 19.05 mm (3/4 in.)
8.
Tighten bolts to the specification shown in the Parts Information.
PARTS INFORMATION
WARRANTY INFORMATION
(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term
Information.)
SYMPTOM B. Replacing The Huck Rivet On The Front Frame Area Due To Noise
DESCRIPTION
A "snapping" or "popping" noise may be heard from the area where the No. 1 cross-member attaches to the left frame Tail. The noise is evident when
