B3000 4WD V6-3.0L OHV (1995)
5.
Use a jumper wire to connect the two (2) pins shown in Fig. 1 to run the fuel pump.
6.
Turn the ignition key "On" with the engine off.
^
Listen for static on the radio.
If the static is present and quits when the jumper wire is removed, proceed to the REPAIR PROCEDURE section of this bulletin.
If the static is not present or continues after the jumper wire is removed, refer to the workshop manual for troubleshooting and repair
instructions.
7.
Install relay.
REPAIR PROCEDURE
1.
Remove the fuel pump sending unit from the fuel tank Refer to section F of the workshop manual for removal instructions.
2.
Remove the negative and positive connectors from the fuel pump.
