B3000 DS Cab Plus 2WD V6-3.0L OHV (2001)
7. Install the lumbar support adjuster and two screws.
8. Install the lumbar adjustment knob.
Vehicles without safety belt buckle pretensioners
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat
removal and installation procedure.
9. Install the 60 percent bench seat.
Vehicles with safety belt buckle pretensioners
10. Restore the vehicle to operating condition.
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat
removal and installation procedure.
1. Remove the 60 percent bench seat.
WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before
repairing or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing,
adjusting or striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches,
strikers, seats and hood latches.
To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).
2. Disconnect the negative battery cable.
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.
3. Reactivate the supplemental restraint system (SRS).
4. Connect the negative battery cable.
5. With all restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).
All vehicles
11. Check the active restraint system for correct operation.
