B3000 DS Regular Cab 2WD V6-3.0L OHV (2002)
f.
Ensure no other aftermarket/dealer installed devices are mounted on the vehicle (especially systems operating on the same 315 MHz
frequency) as the remote transmitters. If aftermarket/dealer installed systems (for example: remote start, perimeter alarm, cell phones or
chargers) are present, disconnect disable, or remove them and recheck remote transmitter operation.
g.
Do not replace or reprogram remote transmitters to correct a range performance concern that affects all remote transmitters. Poor range
performance is most likely caused by the remote keyless entry receiver (control unit), not the remote transmitters.
REMOTE PROGRAMMING
NOTE:
^
You do not need to program remote transmitters after battery replacement.
^
Have all remote transmitters at the time of programming. Any remote not re-programmed will be erased from memory.
^
Vehicle must be electronically unlocked/disarmed (using remote transmitter or driver door mounted unlock button) in order to enter programming
mode.
^
Avoid cross programming of transmitters by reprogramming only one vehicle at a time.
^
If any buttons on a transmitter operate properly, reprogramming a remote will have no effect, perform normal Workshop Manual diagnosis for
inoperative keyless entry.
^
Do not reprogram remotes for poor range performance.
^
If any other remote is operated within 50m (164 feet) of a vehicle while in programming mode, it may be accidentally programmed to that
vehicle.
1.
Unlock the doors using either a remote transmitter or the lock button on the drivers door.
2.
Select correct step by year:
^
1997-2004 Turn ignition from OFF to RUN 8 times within 10 seconds. (Leave the key in RUN the 8th time)
^
1995-1997 Turn ignition from OFF to RUN 5 times within 10 seconds. (Leave the key in RUN the 5th time)
3.
All doors will lock then unlock to confirm entering programming mode.
4.
Press any button on the first remote.
5.
Doors will lock than unlock to confirm programming.
6.
Repeat STEP 4 for up to 4-remotes.
(All remotes must be programmed within 20 seconds, after 20-seconds programming mode will automatically end)
7.
Turn ignition to OFF. Doors will lock then unlock to confirm exiting remote programming mode.
