B3000 DS Regular Cab 2WD V6-3.0L OHV (2002)
Pilot Bearing: Service and Repair
PILOT BEARING REMOVAL / INSTALLATION
1. Remove the transmission.
2. Remove the clutch disc and the clutch cover; refer to the procedure in this section.
3. Use ST or equivalent to remove the pilot bearing from the crankshaft.
4. Inspect the transmission input shaft pilot bearing for:
^
misalignment and looseness in the flywheel.
^
needle rollers for scoring, worn or broken needle rollers, inadequate grease or discoloration.
^
seal leakage.
Note: The transmission input shaft pilot bearing can only be installed with the seal facing the transmission. The transmission input shaft pilot
bearing is pregreased and does not require additional lubrication. A new transmission input shaft pilot bearing must be installed whenever it is
removed.
5. Using a soft-face hammer and the STS or equivalent install the new transmission input shaft pilot bearing into the crankshaft.
6. Install the clutch disc and clutch cover.
7. Install the transmission.