B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
4. Connect the engine wiring harness to the PCM.
5. Connect the PCM to the transmission harness connectors.
6. Connect the engine wiring harness to the oil pressure switch.
7. Connect the engine wiring harness to the heated oxygen sensor connectors.
8. Connect the engine wiring harness to the fuel injectors.
9. Connect the generator wiring harness.
10. Connect the engine wiring harness to the MAF sensor.
11. Connect the engine wiring harness to the ECT sensor, the water temperature indicator sender unit, the CKP sensor and camshaft synchronizer.
12. Connect the 42-pin connector.
13. Install the upper intake manifold.
14. Connect the negative battery cable.
