B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
Terminals 96 - 104
Terminal Voltage (Reference)
*1: When catalyst monitor is on, voltage switches at 0.45 V.
NOTE: All values shown may vary 20% depending on operating conditions and other factors. RPM values are axle and tire dependent.
Using SST (NGS Tester)
1. In the passenger compartment, connect the SSTs (NGS Tester) to the data link connector.
2. Referring to the NGS Tester instruction manual, select "PID/DATA MONITOR AND RECORD" and press "TRIGGER".
CAUTION: The "PID/DATA MONITOR AND RECORD" function is to monitor the the calculation value of the input/output signals in the
PCM. Deviation in the value does not always indicate malfunction in the related devices. For inspection of the input/output signals other than in
the link monitor table, check voltage at the applicable PCM terminal by using the SST (104 Pin Breakout Box).
3. Press Clear to clear previously selected items. (A list of item descriptions appears on the screen.)
4. Select items necessary and press START.
5. Carry out inspection referring to PID/DATA MONITOR table.
6. If normal output signal cannot be detected when all input signals are normal, replace the PCM.
