B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
Valve Body: Procedures
Removal and Installation
CONTROL VALVE BODY REMOVAL/INSTALLATION
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
Note If a transmission has been disassembled to replace worn or damaged parts and the valves in the main control valve body stick repeatedly
from foreign material, the torque converter must be removed and cleaned by using a mechanically agitated cleaner, such as the Torque
Converter/Fluid Cooler Cleaner.
3. Remove the oil pan and oil strainer.
4. Unclip control valve body wire harness.
1. Lift up on wire harness guide and protector and disengage the retaining pins from the solenoid clamps.
5. Disconnect the (1) SST, SS2, SS3 and CCS/SS4 electrical connectors.
6. Disconnect the (2) Torque Converter Clutch (TCC) solenoid electrical connector.
7. Disconnect the (3) Electronic Pressure Control (EPC) solenoid electrical connector.
8. Remove the detent bolt (1) and spring (2).
9. Remove the reverse servo (2).
-
Remove the reverse servo cover and gasket.(1) Discard gasket.
