B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
Assembly Note
1. Install the bearing cup.
1. Start a new bearing cup into the propeller shaft yoke.
2. Position the new spider in the propeller shaft yoke.
3. Using Anoint Tool SST 205-086 (T74P-4635-C) or equivalent, press the bearing cup below the yoke surface.
Note Use the yellow snap rings supplied to assemble the universal joint. If difficulty is encountered with yellow snap rings, install the black
snap rings.
2. Remove the propeller shaft from U joint Tool SST 205-086 (T74P-4635-C) or equivalent and install the snap ring.
3. Repeat Steps 1 and 2 to install the remaining new bearing cups, spider, and propeller shaft yoke.
Note Do not strike the bearings.
4. Check universal joints for freedom of movement.
-
If binding, strike the yoke with a brass or plastic hammer.
5. Install the propeller shaft.
