B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
Transmission Speed Sensor: Service and Repair
OUTPUT SHAFT SPEED (OSS) SENSOR (5R55E) REMOVAL/INSTALLATION
1. Raise and support the vehicle.
2. Disconnect Output Shaft Speed (OSS) sensor electrical connector.
3. Remove OSS sensor.
4. Remove the OSS sensor screw.
5. Remove the OSS sensor from the transmission.
1. Inspect the OSS sensor O-ring for damage. If damaged, replace the O-ring.
6. Inspect and lubricate O-ring with petroleum jelly.
7. Install the (1) OSS sensor into the transmission.
8. Tighten the (2) OSS sensor screw.
9. Connect OSS sensor electrical connector.
10. Lower the vehicle.
