B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
history.
-
If MDCS displays SSP44 D and an Authorized Modification Label is not present, proceed to "C. AUTHORIZED MODIFICATION LABEL
INSTALLATION."
-
If MDCS displays SSP44 D and an Authorized Modification Label is present, the SSP has already been completed. Return the vehicle to the
customer or inventory.
-
If MDCS does not display SSP44 N or SSP44 D, this SSP does not apply to the vehicle. Return vehicle to the customer or inventory.
B.
REPAIR PROCEDURE
Note:
^
Do not replace the GEM when performing this SSR
1.
Record the radio stations presets and disconnect the battery ground cable.
2.
Remove the tilt wheel handle by turning the handle counterclockwise (if equipped).
3.
Remove the three (3) upper and lower steering column shroud retaining screws and remove the shrouds.
4.
Remove the two (2) multifunction switch retaining screws, disconnect the electrical connectors, and remove the multifunction switch. Refer to the
illustration.
5.
Inspect the multifunction switch electrical connector pins to make sure they are not loose or pushed out in the connectors.
6.
Connect the new multifunction switch, making sure the electrical connectors snap into place and are fully seated.
7.
Install the new switch to the column and tighten the screws.
Tightening torque 3 Nm (27 lb-in)
8.
Install the upper and lower steering column shrouds. Tighten the screws.
