mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Brakes - Rear Drum Brake Grabbing Issues|Page 2988 > < Brake Drum|Specifications
Page 1
background image

Brake Shoe: Customer Interest
Brakes - Rear Drum Brake Grabbing Issues

Bulletin No.: 04-007/09

Last Issued: 07/29/2009

Subject:
GRABBING CONDITION FROM REAR DRUM BRAKES

BULLETIN NOTE

^ *This bulletin supersedes the previous bulletin 04-005/04 issued on 09/21/04 and 04-005/08 issued on 03/21/08. The APPLICABLE

MODEL(S)/VINS and REPAIR PROCEDURE have been revised.

^ Changes are shown with asterisks and black lines*.

APPLICABLE MODEL(S)/VINS
*2002-2009 B-Series Trucks*

DESCRIPTION

Some vehicles may experience a grabbing condition from the rear drum brake assemblies during the first few brake applications. The condition only
occurs after the vehicle has been parked for several hours. To reduce moisture intrusion into the rear brake drums, silicone is used to seal the brake 
backing plate.

Customers having this concern should have their vehicle repaired using the following repair procedure.

REPAIR PROCEDURE

1. Verify customer concern.

2. Raise and support vehicle and remove rear wheels.

3. Replace rear brake drum linings using MS3 online or Workshop Manual (section 04-11 REAR BRAKE DRUM REMOVAL / INSTALLATION).

* WARNING:

Do not breathe dust or use compressed air to blow dust from storage containers or friction components. Remove dust using government-approved
techniques. Friction component dust may be a cancer and lung disease hazard. Exposure to potentially hazardous components may occur if dusts are
created during repair of friction components, such as brake pads and clutch discs. Exposure may also cause irritation to skin, eyes and respiratory tract,
and may cause allergic reactions and/or may lead to other chronic health effects. If irritation persists, seek medical attention or advice. Failure to follow
these instructions may result in serious personal injury.*

4. Inspect the rear drum brake assemblies for damaged, missing and/or improperly seated adjuster plug (A) or parking brake cable. Replace any damaged
or missing parts.

5. Inspect and clean rear brake drum surface. Machine if necessary.

Brakes - Rear Drum Brake Grabbing Issues|Page 2988 > < Brake Drum|Specifications