B3000 SE Regular Cab 2WD V6-3.0L OHV (2002)
E.
Lower the front axle.
^
4X4 and 4X2:
A.
Remove the engine support insulator nuts, both sides (Figure 4 shown)
B.
Remove the motor mounts.
C.
Position the new mounts and install nuts
^
4X4 Only, tighten the bottom center nut to 70 Nm (51 lb-ft).
^
4X4:
A.
Raise the front axle assembly into position.
B.
Install axle to frame bolts and two-nuts.
NOTE:
Use new fasteners when installing the front axle.
C.
Install the left front axle to frame bolt and nut.
D.
Position the jack aside.
E.
Connect the axle vent tube.
