B3000 SE Regular Cab 2WD V6-3.0L OHV (2002)
8.
Remove the engine support insulator nuts.
9.
Raise the engine and support with a three-bar engine support (SST 303-F072 or equivalent).
10.
Raise the vehicle on a hoist.
NOTE:
Step 11 through 15 can be performed through the fender well opening.
11.
Remove right hand engine support bracket (three fasteners).
12.
Remove the two-oil filter drain fasteners and position the drain filter aside (left side of engine).
13.
Remove the ground wire attached to the left engine bracket.
14.
Position aside the starter wire harness bracket.
15.
Remove the three left hand engine support bracket fasteners.
16.
Perform the appropriate steps for 4X4 or 4X2 Dual Sport:
^
4X4:
A.
Disconnect the front axle vent.
B.
Support the front axle with a suitable jack.
C.
Remove the left front axle to frame bolt and nut.
D.
Remove the other two axle to frame bolt and nuts.