B3000 SE Regular Cab 2WD V6-3.0L OHV (2002)
Crankshaft Main Bearing Seal: Service and Repair
CRANKSHAFT REAR OIL SEAL REPLACEMENT
1. Remove the flywheel.
Caution: Use care to avoid scratching or damaging the oil seal surface or leakage may occur.
2. Using a sharp awl, punch one hole into the crankshaft rear oil seal metal surface between the seal lip and the cylinder block.
3. Remove the crankshaft rear oil seal using the Jet Plug Remover ST 310-005 (T77L-9533B) or equivalent.
4. Install in the reverse order of removal.
Rear Oil Seal Installation Note
1. Lubricate the outer lips and the inner seal on the crankshaft rear oil seal with clean engine oil.
2. Install the crankshaft rear oil seal using Rear Main Seal Installer ST 49 UN01 064.
3. Install the flywheel.
