B3000 SE Regular Cab 2WD V6-3.0L OHV (2002)
Compressor Shaft Seal: Service and Repair
SHAFT SEAL REMOVAL/INSTALLATION
Removal Note
1. Remove the clutch from the A/C compressor; see MAGNETIC CLUTCH REMOVAL/INSTALLATION.
2. Remove the shaft seal felt from the nose of the A/C compressor with the special tool.
3. Clean the compressor nose area with a lint-free cloth to remove any oil or dirt.
4. Insert the tip of Snap Ring Remover 412-063 (T89P-19623-DH) or equivalent into one of the snap ring eyes.
5. Rotate the Snap Ring Remover to position the tool tip and the snap ring eye closest to the compressor shaft.
6. Pull the Snap Ring Remover up quickly while keeping the tool shaft against the side of the nose opening and remove the snap ring.