mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Clockspring Assembly / Spiral Cable, Air Bag|Description and Operation|Page 3630 > < Clockspring Assembly / Spiral Cable, Air Bag|Description and Operation
Page 1
background image

Clockspring Assembly / Spiral Cable: Service and Repair

AIR BAG SLIDING CONTACT REMOVAL/INSTALLATION

Removal

WARNING:  Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag
module. This will reduce the risk of injury in the event of an accidental deployment.

WARNING:  Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in
the event of an accidental deployment.

WARNING:  Do not set a live air bag module down with the trim cover face down. This will reduce the risk of injury in the event of an
accidental deployment.

WARNING:  After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.

WARNING:  Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.

WARNING:  Air bag modules with discolored or damaged trim covers must be installed new, not repainted.

NOTE:  A repair is made by installing a new part only. It the new part does not correct the condition, install the original pan and perform the diagnostic
procedure again.

1. Prepare the vehicle for clockspring removal.

WARNING:  To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing
or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.

To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (it equipped).

1. Disconnect the negative battery cable and wait at least one minute.

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.

2. Deactivate the supplemental restraint system (SRS). See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION AND

REACTIVATION.

2. Remove the steering wheel back cover plugs.

Clockspring Assembly / Spiral Cable, Air Bag|Description and Operation|Page 3630 > < Clockspring Assembly / Spiral Cable, Air Bag|Description and Operation