B3000 SE Regular Cab 2WD V6-3.0L OHV (2002)
Inertia Fuel Shutoff Switch: Service and Repair
INERTIA FUEL SHUTOFF SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable. See BATTERY DISCONNECT.
2. Access the fuel pump shutoff switch on the right side interior trim panel and disconnect the electrical connector.
3. Remove the bolts and remove the fuel pump switch.
4. Install in reverse order of removal.
Fuel Pump Shutoff Switch Reset Instructions
WARNING: If you see or smell gasoline at any time other than during fueling, do not reset the inertia fuel shutoff (IFS) switch.
1. Turn key off.
2. Check for fuel leaks in the engine compartment.
3. If no leak is apparent, reset the IFS switch by pushing the reset button on the top of the switch (located behind the RH interior trim panel).
NOTE: In the closed position, the button can be depressed an additional 1.57 mm (1/16 inch) against a spring.
4. Turn key to on or start position for a few seconds, then off again.
5. Check for leaking fuel.
