B3000 SE Regular Cab 2WD V6-3.0L OHV (2002)
Ignition Switch: Customer Interest
Ignition Switch - Sticking/Binding/Hard to Turn
09-022/03
1998-2002 B-Series
STICKING OR BINDING IGNITION LOCK CYLINDER OR HIGH EFFORT WHEN TURNING IGNITION SWITCH
APPLICABLE MODEL(S)/VINS
1998-2002 B-Series Truck
DESCRIPTION
Some ignition switch lock cylinders may exhibit the following highly intermittent conditions:
^
Roughness or excessive effort in turning the key from RUN to START position.
^
Key does not fully return from START to RUN after starting vehicle. This may result in intermittent accessory function.
This may be caused by the key-in-ignition warning chime switch. Customers experiencing this concern should have their vehicles repaired using the
following procedure.
REPAIR PROCEDURE
1.
Verify customer concern.
2.
Record customers radio station preset. Disconnect the battery ground cable. Wait at least 1 - minute.
3.
Turn the ignition key to the run position.
4.
Press ignition cylinder release switch (# )1), while pulling the ignition cylinder out.
5.
Remove the plastic key chime warning switch: