B3000 SE Regular Cab 2WD V6-3.0L OHV (2002)
9. Using ST, remove the intermediate band servo cover retaining ring.
1) Install the ST and compress the intermediate band servo cover.
2) Remove the intermediate servo cover retaining ring.
^
Slowly remove tension on the J hook nut and remove the servo cover compressor.
10. Using ST, remove the overdrive band servo cover retaining ring.
1) Install the ST and compress the overdrive/front band servo cover.
2) Remove the overdrive/front servo cover retaining ring.
^
Slowly remove tension on the J-hook nut and remove the servo cover compressor.
Caution: The ST should be used to prevent damage to the servo and bore.
11. Use the ST to remove the front band servo cover, servo piston and servo piston spring.
1) Insert the ST into the transmission case, locate on the servo rod, and remove the front band servo cover, servo piston and servo piston spring.
Installation Note
1. Assemble the intermediate band servo cover, intermediate band servo piston, and the servo piston spring.
1) Install the intermediate band servo piston into the intermediate band servo cover.
2) Install the servo piston spring on the intermediate band servo piston.
Caution: Do not damage O-ring during installation. Do not press servo cover and O-ring past relief hole in case, or O-ring damage may
occur.
