B3000 SE Regular Cab 2WD V6-3.0L OHV (2002)
1. Position the extension housing bushing into the extension housing.
Caution: The lube hole in the extension housing bushing must be aligned with the lube groove in the extension housing. This groove is located at
the 3 o'clock position when viewed from the rear.
Note: Inspect the counterbore of the extension housing for burrs. Remove any burrs from the extension housing counterbore with an oil stone.
2. Use ST or equivalent to install the extension housing bushing.
Caution: The tool will bottom when bushing is in the proper position.
3. Position new extension housing seal with drain hole in the 6 o'clock position.
4. Use ST or equivalent to install the extension housing seal.
Note: Inspect the propeller shaft slip-yoke for wear and damage. Replace if required.
