B3000 SE Regular Cab 2WD V6-3.0L OHV (2002)
1. Install the bearing cup.
1) Start a new bearing cup into the propeller shaft yoke.
2) Position the new spider in the propeller shaft yoke.
3) Using U-Joint Tool ST 205-086 or equivalent, press the bearing cup below the yoke surface.
Note: Use the yellow snap rings supplied to assemble the universal joint. If difficulty is encountered with yellow snap rings, install the black
snap rings.
2. Remove the propeller shaft from U-Joint Tool ST 205-086 or equivalent and install the snap ring,
3. Repeat Steps 1 and 2 to install the remaining new bearing cups, spider, and propeller shaft yoke.
Note: Do not strike the bearings.
4. Check universal joints for freedom of movement.
^
If binding, strike the yoke with a brass or plastic hammer.
5. Install the propeller shaft.
