B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
12.
Turn ignition switch OFF, press TICK.
13.
Install new ABS control module into vehicle, press TICK.
14.
Turn ignition ON, press TICK.
15.
Message "ABS/TCS Module configuration complete", press TICK.
16.
Turn ignition switch OFF, press TICK.
17.
Select "Programmable Parameter". Turn ignition ON, press TICK.
NOTE:
WDS will display an input screen for the ABS/TCS Programmable Parameters.
18.
In the top half of the screen are three listings, select each "white box" and enter the tire information from the vehicle you are working on:
-
Section Width
-
Wheel Diameter
-
Aspect Ratio
NOTE:
Example tire size = P265 / 75 / R15
265 = Section Width / 75 is the Aspect Ratio / 15 is the Wheel Diameter
19.
In the lower half of the screen you will see a calculator. Select the calculator. It will automatically compute the "REVS PER MILE" and enter it
into the correct box. Press TICK.
20.
WDS displays "Tire Size (Rev/Mile)--(GEM) = "the number computed and entered by the calculator".
21.
Confirm the data, press TICK.
22.
Turn ignition switch OFF, press TICK.
23.
4WABS is now configured, disconnect DLC cable.
NGS (VER. 9.0 Card) 2001 Truck PCM Programmable Module Config.
(Programmable Parameters)
1.
Install NGS with Ver. 9.0 card to DLC connector using "flash cable" (P/N 007-00531)
2.
Select "VEHICLE & ENGINE", press TRIGGER.
3.
Select "NEW VEHICLE YEAR & MODEL", press TRIGGER.
4.
Select correct year. Press TRIGGER.
5.
Select correct model and transmission. Press TRIGGER to enter. Press TRIGGER again. Screen shows "Testing supervisor chip" then changes to
menu.
6.
Select "DIAGNOSTIC DATALINK", press TRIGGER.
7.
Select "PCM", press TRIGGER.
8.
Select "MODULE CONFIGURATION", press TRIGGER. Screen shows "Trying to establish communication link".
9.
Screen shows "Attention: Mazda authorizes entry....", press TRIGGER.
10.
Screen shows "Value is unauthorized....", press TRIGGER
11.
Screen shows "Turn key OFF". Do this and press TRIGGER. "Please Wait".
