B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Air Bag Deactivation Switch: Service and Repair
WARNING:
^
To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any air bag system components. To deplete the backup power supply energy, disconnect the battery ground cable and wait one minute.
Be sure to disconnect auxiliary batteries and power supplies (if so equipped).
NOTE:
^
A repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform the
diagnostic procedure again.
1. Disconnect the battery ground cable.
2. Remove ashtray assembly from the instrument panel.
3. Remove in order shown in figure.
4. Install in reverse order of removal.
5. Cycle ignition switch to prove out system.
