B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
6. Loosen the torsion bar adjustment tool until the tension is off the torsion bar.
CAUTION: Secure the front axle shaft to prevent it from overextending. Failure to do so can cause damage to the front axle shaft.
7. Suspend the front axle shaft with wire.
8. Remove the tie rod end castellated nut.
(1) Remove the cotter pin.
(2) Remove the castellated nut.
9. Using the Pitman Arm Puller SST 211-003 (T64P-3590F) or equivalent, separate the tie rod end from the front wheel knuckle.
10. Remove the lower ball joint castellated nut.
(1) Remove the cotter pin.
(2) Remove the castellated nut.
11. Using the SST 211-003 (T64P-3590F) or equivalent, separate the front wheel knuckle from the front suspension lower arm.
