B4000 V6-4.0L SOHC (2005)
Keyless Entry Transmitter: Testing and Inspection
REMOTE KEYLESS ENTRY TRANSMITTER PROGRAMMING
NOTE: All remote entry transmitters are programmable and must be set at the same time.
NOTE: To program (or reprogram) the remote keyless entry transmitters into the RAP module, perform the following steps.
1. Make sure that the passive anti-theft system (PATS) is not armed or triggered.
2. Place the key in the ignition and turn from OFF to ON eight times in rapid succession (within ten seconds) ending in RUN. If the CSM has
successfully entered program mode, it will lock and then unlock all doors.
3. Within 20 seconds, press any button on all transmitters (up to four can be reprogrammed) and the doors will lock and then unlock to confirm that
each transmitter has been programmed.
4. If the door locks do not respond for any transmitter, wait several seconds and press the button again. If the door locks still fail to respond, see
DOORS DO NOT LOCK/UNLOCK USING THE REMOTE TRANSMITTER.
5. Turn the ignition switch OFF, or wait up to 20 seconds after step 2, to exit program mode. If a transmitter has been programmed (or
reprogrammed), the RAP module will lock and unlock all doors one last time to confirm.
