B4000 V6-4.0L SOHC (2005)
23. Disconnect the fuel pressure sensor electrical and vacuum connectors.
24. Remove the fuel injection supply manifold.
1
Remove the four bolts and disconnect the fuel supply tube from the fuel manifold. Position the fuel supply tube aside.
2
Remove the four bolts and the supply manifold and the fuel injectors as an assembly.
Note: Mark each of the roller followers to ensure it is installed in its original position during reassembly.
25. Use the special tool to remove the roller followers.
Note: The special tool must be installed on the damper and should contact the engine block. This positions the engine at top dead center (TDC).
26. Using the special tool, set the number 1 piston to TDC.
